Click on the appropriate buttons in the illustration.
Starter body
Terminal 50
Terminal C
Field coil lead wire
Terminal 30
Test lead A
Hold-in coil
Pull-in coil
Pinion gear
Check that the pinion gear returns
to its original position.
1.
Pinion return test
(1)
With the pinion gear extended after the hold-in test, disconnect the grounding wire from the starter body.
(2)
Make sure that the pinion gear returns to its original position.
HINT:
•
Artificially creating the state in which the ignition switch returns from the START position to the ON position, will disconnect the electricity supply to the hold-in coil and allow the pinion to return.
•
Replace the magnet starter switch assembly if the pinion gear
does not return to its original position.
