|
(3)
|
Fully tighten suspension cross member and centre member mounting bolts to the required torque.
|
|
NOTICE:
|
|
•
|
Do not remove the engine sling device until the
installation of the members and the engine mounts has been completed.
|
|
•
|
If the engine sling device is removed with the
bolts just hand-tightened, the resulting loads on the bolts will make it impossible
to tighten each bolt to the required torque.
|
| |
| (4) |
Remove the jack. |
| |
| (5) |
Install and tighten the engine mount mounting bolts and nuts. |
| |
| (6) |
Install and tighten the stabilizer. |
| |
|
(7)
|
Remove the engine sling device from the chain
block.
|
